Reading Timeout And Delay - Newland HR200 User Manual

Programming the Engine Programming the Engine

Reading Timeout and Delay

One Reading Timeout：If the engine doesn't read any barcode during the
timeout period, it will stop reading automatically. One Reading Timeout is
valid in Auto mode. The default timeout is 3000ms.
Same Barcode Reading Delay：It is used to avoid misreading on the same
barcode (the same format and message) in a Same Barcode Reading Delay
Time. It is valid only in Auto and Continuous modes. The default delay is
1500ms.
One Reading Timeout
【Pro CMD：0313000】
There are two options available in Same Barcode Reading Delay:
(Multi-reading) Prohibit: The same symbol can be read after delay.
»
(Multi-reading) Semi-prohibit: The same symbol can be read more than once in the delay period
»
if ambient illumination is changed, for example the bar code is removed out of reading area and moved
back.
** Multi-reading Semi-prohibit
【Pro CMD：0313020】
To set One Reading Timeout to 1500ms, read these programming codes:
1、 "Code Programming ON"
2、
"One
3、 Digit Code "1","5","0","0", see Digit Code
4、 "Save Programming"
nlscan.com
Reading Timeout"
Code Programming ON
Code Programming OFF
Same Barcode Reading Delay
【Pro CMD：0313010】
Multi-reading Prohibit
【Pro CMD：0313030】
Tools
Page 22