4.7.17 FDD, COM, LPT PORT
When Enabled, the system will resume from suspend mode if FDD, COM
port, or LPT port is active. The choice: Enabled, Disabled.
4.7.18 PCI PIRQ [A-D]#
When Enabled, the system will resume from suspend mode if interrupt
occurs. The choice: Enabled, Disabled.
4.7.19 PWRON After PWR-Fail
Off
When power returns after an AC power failure, the system's power
is off. You must press the Power button to power-on the system.
On
When power returns after an AC power failure, the system will
automatically power-on
Former-StsWhen power returns after an AC power failure, the system
will return to the state where you left off before power failure
occurs. If the system's power is off when AC power failure
occurs, it will remain off when power returns. If the system's
power is on when AC power failure occurs, the system will
power on when power returns.
4.8 PnP/PCI Configurations
This section shows how to configure the PCI bus system. It covers some
very technical items and it is strongly recommended that only experi-
enced users should make any changes to the default settings.
4.8.1
Reset Configuration Data
Default is Disable. Select Enable to reset Extended System Configuration
Data (ESCD) if you have installed a new add-on and system configura-
tion has caused such a conflict that OS cannot boot.
Enabled: The BIOS will reset the Extended System Configuration Data
(ESCD) once automatically. It will then recreate a new set of
configuration data.
Disabled: The BIOS will not reset the configuration data.
49
Chapter 4