Lcd Power Setting (J6); Installing The Ddr Sdram Memory Module; Installing A Compact Flash Card - Advantech ARK-3384 Series User Manual

Table 3.2: LCD Power Setting (J6)
Close pins
1-2
2-3
(*): means default setting of the jumper/function
Please also refer to Chapter 9 of "Full Disassembly Procedure".
The default setting of J6 is 5V.

3.5 Installing the DDR SDRAM Memory Module

The ARK-3384 provides one 200-pin SODIMM (Small Outline Dual
Inline Memory Module) socket and supports 2.5 V DDR SDRAM. You
can install from 64 MB up to 1 GB of DDR SDRAM memory. The proce-
dure for installing a DDR SDRAM SODIMM into the ARK-3384 is
detailed below, please follow these steps carefully.
3.5.1 Remove the power cord.
3.5.2 Unscrew the four screws from the bottom cover of the ARK-3384.
3.5.3 Remove the bottom cover.
3.5.4 Carefully insert a DDR SDRAM SODIMM into a DDR SDRAM
SODIMM on board.
3.5.5 Screw back the bottom cover with the four screws.

3.6 Installing a Compact Flash Card

The procedure for installing a CompactFlash card into the ARK-3384 is
detailed below, please follow these steps carefully.
3.6.1 Remove the power cord.
3.6.2 Unscrew the two screws from the CF door located on rear face
plate of the ARK-3384 embedded box computer.
ARK-3384 User Manual
Function
+5V*
+3.3V
22