Config; Config Pages; Config | Amplifier; Figure 4-6. Config | Amplifier Page - Comtech EF Data LPOD Installation And Operation Manual

LPOD Outdoor Amplifier / Block Up Converter
Ethernet-based Remote Product Management
Click [Submit SNMP] to save any changes. Otherwise, click [Reset] to revert to the previously
assigned SNMP designations.
4.5.4.3

Config Pages

Click the Config tab, and then click the Amplifier, LNB, Utility, or Redundancy hyperlink to
continue.
4.5.4.3.1

Config | Amplifier

Use this page to configure the communications, operations, and alarms/faults handling for the
amplifier.
Click [Refresh] (at the top of the page) to update the page appearance to the current operating
configuration.
Serial
•
Remote Address – Enter a valid physical remote address from 0001 to 9999.
• Baud Rate – Use the drop-down list to select the operating baud rate as 2400, 4800, 9600,
19200, or 38400 baud
Click [Change Serial Configuration] to save any changes.
Amplifier

Figure 4-6. Config | Amplifier Page

4–18
Revision 9
MN-LPOD