LPOD Outdoor Amplifier / Block Up Converter
Ethernet-based Remote Product Management
•
An operating parameter is changed, e.g., when a command that changes an operational
value is executed successfully;
•
A fault condition is triggered;
•
A redundant switchover occurs.
4.5.4.4.2
Status | Status
Use this read-only page to review all pertinent information about the LPOD.
Unlike the remaining pages available through this interface that refresh/update
only when manually selected, the 'Status | Status' page updates automatically
once every 10 seconds. Even with this automatic refresh function, you may click
[Refresh] to update the operational status parameters found on this page.
Figure 4-11. Status | Status page
4–25
Revision 9
MN-LPOD