Comtech EF Data LPOD Installation And Operation Manual page 65

LPOD Outdoor Amplifier / Block Up Converter (BUC)
Updating Firmware
o Your Ethernet connection may use either the CAT5 Ethernet adapter cable
B. On the PC – If not using the CLC-10, configure the terminal emulator program if applicable.
Configure the utility program serial port communication and terminal display operation:
• 38400 bps (Baud Rate)
• Parity = NO
• Local Echo = ON
C. On the LPOD – Power up the unit. Your power connection varies depending on your
ordered unit.
(CEFD P/N CA-0000352) to directly connect the PC Ethernet port to the LPOD, or
the optional LPODnet M&C Netbook Accessory Kit (CEFD Kit KT-0000203). The
following example depicts use of the LPODnet for 1:1 Redundant or Standalone
Ethernet connection:
Refer to your terminal emulator program HELP feature or user guide for
operating and configuration instructions.
• 8 Data Bits
• Port Flow Control =
See Sect. 2.2.3 Connector 'J3 | POWER IN' (AC Power Mains) or Sect. 2.2.4
Connector 'J3 | POWER IN' (DC Power Mains) in this manual for your specific
power connectors.
NONE
3–3
Revision 9
MN-LPOD
• 1 Stop Bit
• Display New line Rx/Tx: CR