Comtech EF Data LPOD Installation And Operation Manual page 136

LPOD Outdoor Amplifier / Block Up Converter (BUC)
Serial-based Remote Product Management
Command Arguments
(Instruction for Command
Parameter Type
Code and or Response
Qualifier) to Query
Reference REF= 3 bytes
Oscillator Tuning
Retrieve N/A 22 bytes
Equipment Type
E
RF Power FET N/A variable length
Current Status depending on
the number of
FETs installed
in the RF
amplifier
Description of Arguments
(Note that all arguments are printable ASCII characters)
Command or Query.
Sets or returns the reference oscillator tuning voltage adjustment by sending a DAC value in the form xxx,
where:
xxx = is a numeric value from 0 to 255.
Default value: 087
Note: This command sets the DAC value, but the actual Reference Oscillator tuning voltage can be monitored
using the RMS command.
Example: <1/REF=087'cr'
>0001/REF='cr''lf'
Query only.
Returns a string indicating the Model Number and the version of the M&C firmware installed in the unit.
Example: <1/RET?'cr'
>0001/RET=PS2053-5967-C REF BUC VER: 1.5.2'cr''lf'
Query only.
Returns all FET currents in the form xx.x when the value is >1 Amp, or xxx when the value is < 1 AMP
Example: <1/RFS? 'cr'
>0001/RFS='cr'
Q01=.xxx'cr'
Q02=.xxx'cr'
Q03=xx.x'cr'
Q04=xx.x'cr'
Q05=xx.x'cr'
Q06=xx.x'cr'
Q07=xx.x'cr'
Q08=xx.x'cr'
Q09=xx.x'cr'
Q10=xx.x'cr'
Q11=xx.x'cr'
Q12=xx.x'cr'
Q13=xx.x'cr'
Q14=xx.x'cr'
Q15=xx.x'cr'
Q16=xx.x'cr''lf'
5–28
Revision 9
MN-LPOD
Response to Query
Response to Query
Command (Instruction
(Target to
(Target to Code and
Controller)
Controller) Qualifier)
REF= REF? REF=xxx
REF? (See Description of
REF* Arguments)
RET= RET? RET=x....x
(See Description of
Arguments)
RFS= RFS? RFS=x....x
(See Description of
Arguments)