Replacing The Loop Clutch - Konica Minolta 7145 Service Manual

DRIVE SECTION
5. Reinstall the above parts following the removal
steps in reverse.
Note:
• When installing the registration clutch [1], be sure
to set the groove of the clutch detent in the stop-
per [3].
2.3

Replacing the Loop Clutch

A. Procedure
1. Remove the system control board unit.
• For removal procedure, see "2.1 Removing and
reinstalling the motor units (main, fixing, feed,
developing)".
2. Remove the wire bundle from the clamp on the
conveyance drive panel [1].
3. Remove the 2 E-rings [2], 3 screws [3] and 2
bearing [4] , and remove the conveyance drive
panel [1]. (Do not remove the rotation preven-
tion screws on the clutch.)
4. Remove the E-ring [1], then remove the gear [2]
and the connector [3], remove the gear [4] at the
front, and then remove the clutch [5].
5. Reinstall the above parts following the removal
steps in reverse.
[3]
[1]
[3]
[4]
[2]
[5]
[3]
[4]
[1] [2]
3-6
[2]
[1]