Konica Minolta 7145 Service Manual page 146

FIXING UNIT
4. Detach the faston terminal [1] at the front of
each lamp.
5. Remove the 2 screws [2], and remove the lamp
support piece/F [3].
6. Keeping all cord faston terminal wiring straight,
pull each fixing heater lamp/1 [4], /2 [5] toward
you to remove.
7. Reinstall the above parts following the removal
steps in reverse.
Note:
• When installing, be sure that manufacturer's mark
is mounted on the front side.
• Do not allow the heater lamps to make contact
with the inside of the roller.
• Install so that the main lamp is at the top, and the
sub lamp is at the bottom.
Heater cords are color-coded as follows.
Color Positions
Lamp JAPAN
Front Rear Front Rear Front Rear
Main White White Red
Sub White Black Red Black Blue Black
• When installing the faston terminal on the drive
gear side, be sure that the installation position is
correct.
EUROPE
U.S.A.
OTHERS
Red Blue Blue
3-54
[1]
[3]
[4]
[5]
[2]