Konica Minolta 7145 Service Manual page 301

10.17 Fold Angle Adjustment of
SK-114
• It is performed when the fold unit is replaced or a
tilt occurs in paper folding.
A. Procedure
1. Enter the Crease mode and make a copy. (A3
Size)
2. Fold the output paper and half and check
whether section A of the paper is aligned.
Specification: 0 ± 1.5mm
3. If the fold position is slanted as shown on the
left, make the following adjustment.
4. Open the Front Door, loosen one adjustment
screw, and move the Crease Unit to the left to
make the adjustment.
* If the fold position is slanted opposite to the
figure of step 3, move the Crease Unit to the
right to make the adjustment.
5. Make another copy and check the fold position.
1-111
OTHER ADJUSTMENTS
A
Center
Fold
4511D529AA
4511D530AA
1