Replacing The Registration Clutch - Konica Minolta 7145 Service Manual

2.2 Replacing the Registration
Clutch
Caution:
• Be sure to remove the drum unit from the
main body before carry out the following pro-
cedure. If the drum unit is in place at this
time, the drum will rotate when you install or
remove the drum rotating plate, resulting in
possible damage to the cleaning blade.
A. Procedure
1. Remove the system control board unit.
• For removal procedure, see "2.1 Removing and
reinstalling the motor units (main, fixing, feed,
developing)".
2. Remove the set screw [1], and remove the drum
rotating plate [2].
3. Remove the clutch connector [1].
4. Remove the E-ring [2]. Pull the registration
clutch [3] toward you and rotate it to remove.
[2]
[1]
[3]
[1]
[2]
3-5
DRIVE SECTION