Tray Tilt Adjustment - Konica Minolta 7145 Service Manual

10.6 DB-411 Tray Tilt Adjustment
Normal paper feed can't be expected if the tray is
tilted. In such case, adjust the tray and paper feed
roller shaft so that they may be parallel in each
other. Whenever the wire is replaced, this adjust-
ment must be implemented.
A. Procedure
1. Remove the front cover of the tray.
2. Loosen a screw [2] of the wire adjustment part
[1] situated in front side of the tray.
3. Position in front and in rear the 2 metal scales
[2] in the tray [1] as shown in the drawing.
4. Move the wire adjustment part [3] until the dis-
tance from top of the side plate to the tray [1] top
face is equal in both the front and back sides.
5. When the adjustment is complete, tighten the
screw [4] for the wire adjustment part [3].
[1]
[1]
[3]
[4]
1-95
OTHER ADJUSTMENTS
[2]
[2]