Konica Minolta 7145 Service Manual page 141

3. Remove the 2 stop rings [1] and the bearing [2]
on this side, and remove the paper feed roller
unit [4] by sliding the bearing [3] on the rear side
to the rear.
4. Remove the collar [1] and pull out the feed shaft
[2].
5. Remove the feed rubber [4] from the feed roller
[3].
6. Remove the stop ring [5] and pull out the paper
feed shaft [6].
7. Remove the paper feed rubber [8] from the
paper feed roller [7].
8. Reinstall the above parts following the removal
steps in reverse.
Note:
• Be sure to install the feed rubber [4] so that the
paint mark [9] is turned in the direction as shown
in the illustration.
• Install the paper feed roller unit so that the hook
of the paper feed roller unit comes above the
paper feed roller unit release arm.
[2]
[1]
[8]
[5]
[9]
3-49
PAPER FEED UNIT
[4]
[3]
[1]
[7]
[6]
[2]
[1]
[4]
[3]
[11] [10]