Control By External Device; Emc; Pin Configuration (Pyramix Controlled By External Device) - Merging Pyramix User Manual

Then select: Pyramix : Download :
load.
For links to Controller and Console manufacturers go to:
Then select: Pyramix : Controllers and choose the relevant manufacturers link.

Control by External Device

If Pyramix is to be controlled by another device or devices, these are installed via Settings > All Settings Remote
Control > Controller (See: Controller on page 543 ) and, where applicable, Pyramix functions are mapped to the
controller via the Settings > All Settings > Project > Controller Mapping page. (See: Controller Mapping on
page 512)

9-pin Configuration (Pyramix controlled by external device)

Please see: Sony 9 - Pin Protocol Configuration (Pyramix controlled by external device) on page 545

EMC

Scope
EMC includes HUI and Mackie Control Support.
The following controllers are supported and validated:
• Mackie MCU in HUI and MackieControl modes
• Yamaha DM1000 in HUI mode
• Yamaha DM2000 in HUI mode
• Raditec SAC2-k in HUI mode (MackieControl is not working properly)
• Tascam US-2400 in HUI mode (US-2400 MackieControl mode is specifically configured for other DAWs
than Pyramix)
Key
Valid Remote Control Support and Remote Control – Midi Enhanced Midi protocol keys are required to use EMC.
Documentation
: Controllers, and choose the required document for down-
www.merging.com
Remote Control : Control by External Device 22 - 392