Pyramix V6 Latency Modes For Masscore - Merging Pyramix User Manual

Note: These bars should be ignored when loading a project, making changes in the
graphical layout of Pyramix when stopped (opening pages, moving the mixer, etc.), or
doing offline processes (renders, non real-time mix-downs, etc.). If the indicators
become red during these phases of your work, simply click on the indicator bar to reset
it.
Very Important!
For the present we recommend that you do not use more than 65-70% of the Core resources to avoid glitches or
problems related to intensive graphic refresh bursts. Three colour zones have been set for the Core load indicator.
0% to 65% Green zone (best performance)
65% to 75% Orange zone (moderate risk)
75% to 100% Red zone (performance could be at risk if major screen redraws are initiated by the user)
For ultimate performance Vista should be run on a QuadCore processor.

Pyramix V6 Latency Modes for MassCore

Pyramix V6 Latency Modes
Mykerinos/Latency (Note1
MYK-MB1
MYK-MB2
MYK-MB3
MYK-MB4
MYK-MB5
MYK-X30
MYK-X50
Note 1: Latency Modes introduce relative performance penalties. Low: 11%, Extra:22%, Ultra:44%
Latency measurements are LIVE IN to LIVE OUT
Note: Please be aware that our competitors only take in account latency from Live In to
Record; in our case this would means 0.665ms in Ultra-Low, 1.33 in Extra-Low and
2.66 in Low Latency, but, since from Live In to Live Out is the 'real-world' figure, we cal-
culate it as 1.33ms , 2.66ms , 5.33ms respectively.
for MassCore
Low Latency
)
(5.33ms)
v
v
v
v
v
v
v
MassCore : Pyramix V6 Latency Modes for MassCore
Extra Low Latency
(2.66ms)
v
v
Ultra Low Latency
(1.33ms)
v
v
2 - 34