Figure 2.3 Device Manager - Advantech PCI-1730U User Manual

Note! In case you installed the card without installing the Device Drivers first,
Win95/98/ME will recognize your card as an "unknown device" after
rebooting, and will prompt you to provide the necessary driver. Ignore
the prompting messages (just click the Cancel button) and set up the
driver according to the steps described in 2.2 Driver Installation.
After the PCI-1730U/1733/1734 card is installed, you can verify whether it is properly
installed on your system in the Device Manager:
1. Access the Device Manager through Control Panel/System/Device Manager.
2. The device name of the PCI-1730U/1733/1734 should be listed on the Device
Manager tab on the System Property Page.
Note! If your card is properly installed, you should see the device name of your
card listed on the Device Manager tab. If you do see your device name
listed on it but marked with an exclamation sign "!", it means your card
has not been correctly installed. In this case, remove the card device
from the Device Manager by selecting its device name and press the
Remove button. Then go through the driver installation process again.
After your card is properly installed on your system, you can now configure your
device using the Device Installation Program that has itself already been installed on
your system during driver setup. A complete device installation procedure should
include device setup, configuration and testing. The following sections will guide you
through the Setup, Configuration and Testing of your device.

Figure 2.3 Device Manager

13 PCI-1730U/1733/1734 User Manual