Mainframe And General Specifications - Newport 6000 Operation And Maintenance Manual

Chapter 10
Temperature Calibration
Thermistor
AD590
LM335
Pt RTD
10.4

Mainframe And General Specifications

Display
Type
Back Lighting
Controls
Channel Active
Output Connectors
Temperature Controller (TEC)
Laser Diode Driver (LDD)
MOPA (6000M and 6000MF only)
Chassis Ground
GPIB Connector
RS232 Connector
Power Requirements
50 to 60 Hz
Size (H x W x D)
Mainframe Weight
Modules Weight
Operating Temperature
Storage Temperature
Laser Safety Features
Isolation
earth ground.
In accordance with ongoing efforts to continuously improve our products, Newport
Corporation reserves the right to modify product specifications without notice and
without liability for such changes.
Specifications
1/T = (C1 x 10 -3 ) + (C2 x 10 -4 )(ln R) + (C3 x 10 -7 )(ln R) 3
T = C1 + C2 x (I /1µA/K - 273.15)
AD590
T = C1 + C2 x (V /10mV/K - 273.15)
LM335
Rt = Ro [ 1 + C1t + C2t 2 ] ; t ≥ 0 °C,
Rt = Ro [ 1 + C1t + C2t 2 + C3t 3 (t - 100)] ; t < 0 °C
Ro = resistance at 0 °C where, Ro=100Ω for a 100Ω Pt RTD.
LCD character display, 4 lines by 20 characters
Green LED
Brightness and Contrast (contrast optimizes viewing angle)
For Model 6000, Green LDD LED indicates that Laser Diode output is on. Green
TEC ACTIVE LED indicates that TEC output is on. For Model 6000M and
6000MF, Green OSC LED and AMP LED indicate the oscillator and amplifier are
on, respectively. The on state of the TEC is indicated on the master display. The
LCD display shows details of active channels.
15-pin female D-sub
9-pin female D-sub, BNC (external modulation), BNC (auxiliary photodiode input)
15-pin female D-sub, BNC (external modulation)
4 mm Banana Jack
24 pin IEEE-488
9-pin male D-sub
90 to 132 volts, 2.25 Amp Max.; 198 to 250 volts, 1 Amp Max. (user selectable),
86 mm x 356 mm x 356 mm (3.5 " x 14" x 14")
9.5 kg (21 lbs.)
1.1 kg (2.5 lbs.), typical weight each
0 to 40°C, < 70% relative humidity non-condensing
-20°C to 60°C, < 90% relative humidity non-condensing
Laser Enable Key switch, Interlock, Output Delay (meets CDRH US21 CFR
1040.10). Interlock and output delay are part of the Laser Module.
TEC and Laser sections electrically isolated with respect to each other and from
101