Table of Contents
Advertisement
54
Chapter 5
5.3.1
TEC Grounding Consideration
The TEC output of the module is isolated from chassis ground, allowing either output
terminal to be grounded at the user's option.
5.4
TEC Module Operation
5.4.1
Quick Start
After the power-on sequence is complete, the 6000 goes to the Master display. To
set up a TEC module, press the MENU button, then the Modules soft key, then
select the TEC module, and finally, the Setup soft key. At this point, the display
shows all TEC parameters. Using the cursor keys and knob, select the desired
functions and set the parameter values. When finished, return to TEC display with
Enter the desired set point value using the cursor keys or the knob. Press the TEC
ON soft key to operate the TEC. The LED illuminates to indicate TEC operation. To
turn the TEC off, press the TEC ON key again.
5.4.2
TEC Main Screen
The TEC main screen is shown Figure 29 and described below.
Is=, Ts=, Rs=, is=, vs= - Indicates the set point value of current, temperature,
resistance, AD590 sensor current, or LM335 sensor voltage. In the screen shown
above, the Ts is shown. Is, Rs, is, and vs would be seen when operating in those
modes.
Pin
1,2
3,4
5,6
7
8
Table 4 - TEC Connector Pintouts
(previous) soft key.
Ts= 25.00 °C
→ → → →
T=
Ite= 0.000 A
I V T R C InT SETUP
Temperature Controller Operation
Description
TE+
TE-
Ground
Sensor+
Sensor-
25.00 °C
Figure 29 - TEC Main Screen
← ← ← ←
Advertisement
Table of Contents
