Table of Contents
Advertisement
Chapter 2
2.3
Introduction to the 6000 Front Panel
2.3.1
Model 6000
Described below are the functions of each area of the Model 6000 front panel, as
shown in Figure 1. See the following section for the Model 6000M and 6000MF.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. MENU Key - Switches to the main menu from any screen in the system (see
11. FUNCTION Key - Used to execute user macros and special functions (see
12. SHIFT Key - Toggles between the outer and inner set of soft keys.
13. Remote LED - Indicates 6000 is in remote mode.
14. Knob - Used to continuously vary certain parameters. The knob has an
Figure 1 - Model 6000 Front Panel
Power On/Off Switch - Switches on/off the AC power to the unit.
Laser Enable On/Off Switch - Safety key-switch that enables/disables laser
output. See sections 3.6 and 4.3.4 for additional information on laser interlock.
Laser Active LED - Indicates laser output is on.
LDD On Button - Turns the laser output on/off.
TEC Active LED - Indicates TEC output is on.
TEC On Button - Turns the TEC output on/off.
Display Soft Keys - These are the two dark keys located to the right of the
display. The function of these keys varies depending on what menu is displayed.
See section 2.4.1.4 for a complete description of soft keys.
MASTER Key - switches to the master display from any screen in the system
(see section 2.4.2).
Cursor Control Keys - Moves cursor up or down between editable data fields.
The left arrow decrements values in numerical entry fields, or as a previous
choice in a multi-choice entry field. The right arrow increments values in
numerical entry fields, or as a next choice in multi-choice entry fields. See
section 2.4.1.3 for a description of data fields.
section 2.4.6).
section 2.4.2).
acceleration factor that causes the rate of change to increase as the knob is turned
System Operation
9
Advertisement
Table of Contents
