Table of Contents
Advertisement
All/Perimeter Syste m Arming
Area Assignment: Your security system is divided into two
separate areas. Motion detectors, inside doors, and other interior
protection devices are assigned to the Interior area while windows
and exterior doors are assigned to the Perimeter area.
Perimeter or All: When arming an All/Perimeter system, the
keypad displays PERIM
the Perimeter and the Interior of the system. You will want to arm
both of these areas when leaving with nobody left inside. Selecting
PERIM arms only the Perimeter of the system. Perimeter arming is
for when you are staying inside but want the comfort of knowing
the exterior doors and windows are armed.
allows you to move freely about inside without setting off any
interior alarms.
System Ready/System Not Ready Keypad Displays
When all zones in the system are in a normal condition, the keypad
displays SYSTEM READY. If there are one or more zones that are
not in a normal condition, the keypad displays SYSTEM NOT READY.
Pressing any top row Select key during this display shows the zone
name allowing you to investigate the problem.
Instant Arming
Instant: During the exit delay time, you can cancel the exit and
entry delays and cause all zones to be instant zones. Press the far
right select key under INSTNT while the exit delay is displayed.
This immediately arms the exit zones. However, no entry delay is
provided and an alarm will occur should an entry door be opened.
10
ALL. If you select ALL, you arm both
Perimeter arming
Arming an All/Perimeter System
1.
Enter your code. The keypad displays PERIM
2.
Select PERIM to arm the Perimeter area only.
3.
Select ALL to arm both the Perimeter and Interior areas.
4.
The keypad displays any bypassed zones and 24-hour zones
that are in a bad condition. No action is required by you.
5.
At this point you can force arm or bypass any bad zones. A
zone that is force armed will be restored into the system if
it later returns to normal. A bypassed zone remain bypassed
until the system is disarmed. See steps 5a through 5d.
5a.
If a problem exists on any zones, the zone name and
problem are shown followed by: OKAY BYPASS STOP.
5b. Select OKAY to force arm the zone(s) before arming.
5c. Select BYPASS to bypass the zone(s) before arming.
5d. Select STOP to stop the system from arming. Correct the
zone problem(s) and return to step 1.
6.
The keypad displays PERIMETER ON if only the perimeter is
being armed and ALL SYSTEM ON if both the perimeter and
interior are being armed.
7.
The keypad next displays EXIT: ## INSTNT and begins to
count down the number of seconds remaining for you to
exit. When the delay expires, all zones are armed.
8.
You can select INSTNT while EXIT: ## INSTNT is displayed
to immediately arm all zones and make them instant. The
keypad displays INSTANT.
9.
When the system is fully armed, the keypad displays
PERIMETER ON for perimeter arming and ALL SYSTEM ON
for perimeter and interior arming.
XR20 User's Guide
ALL.
Arming and Disarming
Advertisement
Table of Contents
