Special Security Command Displays - Security Command XR20 User Manual

Special Security Command Displays

As you use your system, you will occasionally see a keypad display
that asks you to enter a user code or describes a condition on the
system. Below are some examples of the displays you will see.
ALARM
A 24-hour zone, such as a Þ re or panic zone, or an armed burglary
zone has been faulted. Your system may sound bells or sirens.
ALARM CANCELLED
This message displays when an authorized user has cancelled
an alarm condition by entering a valid user code and an "Alarm
Cancelled" report was sent to the central station.
TROUBLE
There is a problem with a protection device or system component.
This display is accompanied by a description of the problem.
ENTER CODE
The system requires you to enter a personal user code.
codes can be required for turning your system on (arming), turning
your system off (disarming), and performing many other system
options.
As you enter your user code, the keypad display shows an asterisk
(*) in place of each digit pressed. This prevents others from seeing
your user code on the display as it is entered.
TRY AGAIN
The user code entered is not recognized by the system. Check the
user code and try again.
4
INVALID CODE
The user code you have entered is considered invalid by the
system.
SYSTEM TROUBLE or SERVICE REQUIRED
There is an electronic failure in your system. Contact the service
department as soon as possible.
User
XR20 User's Guide Introduction