Troubleshooting - Clarke TIGER 2500 Operation & Maintenance Instructions Manual

TROUBLESHOOTING

If the following does not solve your problem, please contact the CLARKE service
department.
PROBLEM
Engine will not
start (see engine
manual for
further engine
troubleshooting)
Lack of pressure
(initial use)
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
CAUSE
No fuel.
Low oil.
Pressure builds up after
two pulls on the recoil
starter or after initial use.
Spark plug lead not
attached securely.
Engine switch is in the
OFF position.
Choke lever is set to the
ON position when the
engine is already warm.
Fuel valve closed.
Leak in the high pressure
hose fitting.
Nozzle is obstructed.
Water filter screen is
clogged.
Air in the hose.
SOLUTION
Add fuel.
Add oil.
Squeeze the gun trigger to relieve the
pressure.
Attach the spark plug lead.
Set the engine switch to the ON position.
Set the choke lever to the OFF (right)
position.
Open the fuel valve.
Tighten the fitting, use sealant tape if
required.
Clear the nozzle.
Remove and clean the filter.
Turn off the engine.
Turn off the water supply.
Disconnect the water source from the
pump inlet and turn on the water source
to expel the air from the hose.
When all the air has been removed, turn
off the water supply and reconnect the
hose.
Turn on the water supply and pull the
trigger to expel any air in the gun/lance.
19