Applying Detergents And Cleaning Agents; Shutting Down - Clarke TIGER 2500 Operation & Maintenance Instructions Manual

APPLYING DETERGENTS AND CLEANING AGENTS

To improve the cleaning performance, you can introduce chemical cleaning
agents (detergents) to the water jet using the detergent pickup hose.
1. Place the detergent pickup hose
into a container holding the
chemical/cleaning solution.
• Only use detergents
recommended for use with
pressure washers, such as
CLARKE Traffic Film Remover
which is a powerful low
foaming agent for car
cleaning, patio cleaning etc.,
or CLARKE Wash & Wax, both
available from your CLARKE dealer.
2. Hold the rear of the nozzle on the
high pressure lance and slide the
front of the nozzle forwards to low
pressure.
3. Spray the detergent onto the
vehicle, patio etc.
• Allow the detergent a little time
to work itself into the grime.
CAUTION: IF YOUR EYES COME INTO CONTACT WITH ANY CLEANING
FLUIDS, RINSE THEM IMMEDIATELY WITH PLENTY OF FRESH CLEAN WATER.
AND SEEK MEDICAL ADVICE IF REQUIRED.
4. To rinse, remove the detergent pickup hose from the container holding
chemical/cleaning solution, slide the front of the nozzle on the lance back
towards the handle and use the pressure washer as normal.

SHUTTING DOWN

1. After each use, if you have
applied chemicals, place
detergent pickup hose into a
container of clean water and run
clean water through detergent
pickup hose to flush the system
thoroughly.
2. Move the throttle control lever to
the right.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
14