Dimensions ............600X400X680mm Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the machine’s data plate...
Thank you for purchasing this KING 135 Hot Washer. This machine is a lightweight, portable, high pressure power washer, designed for DIY and light commercial use ONLY It comprises an electric motor, a pump, a high pressure hose with a trigger and lance, and an adaptor for injecting foam or cleaning agents into the water jet.
11. Children should not be allowed to use the machine. 12. We recommend the use of safety goggles when using machine in For Spare Parts and Service,please contact your nearest dealer, or CLARKE International, on one of the following numbers.
Replace 1 amp fuse (see page 13) hot water If problem persists, contact your Clarke dealer. Should the machine fail to operate, despite carrying ou the above procedures, it is probable that it requires servicing. Please contact your Clarke dealer.
ELECTRICAL CONNECTIONS PARTS LIST Description Part No. WARNING: THIS MACHINE MUST BE EARTHED..MPVR36616 Cover ................his product is provided with a standard 13 amp, 230 volt (50Hz), BS 1363 plug, for ..MPVR46081 Red Cover ............... connection to a standard, domestic electrical supply..
PARTS DIAGRAM ASSEMBLY AND PREPARATION FOR USE Firstly assemble the hose bracket to the frame using the 4 screws and nuts provided. The Lance Fig.1. The lance is assembled by screwing the two sections together. Remove the travel plug from the outlet port, at the front of the machine (A Fig.2.
Page 8
If the filter is loose, ensure it is attached Should the machine stil fail to start, following the reset procedures, then the problem is likely to the end of the detergent pick-up hose to be more serious. Contact your Clarke dealer before use. Use ONLY those detergents specifically designed for use with Power Washers.
NEVER attempt to run the machine with the water supply disconnected electrodes and calibrate and check the safety devices. Please contact your Clarke dealer. or turned off.
C. SHUTTING DOWN THE MACHINE Fig.9. Fig.8. If the burner has been used, switch it OFF FIRST by pressing the rocker HIGH switch, on the side of the unit, to ‘O’ (OFF). PRESSURE is set by Allow the pump to run for a minute or so until the water being ejected is pulling IN or pushing cold then switch OFF the pump by pressing the switch to ‘O’...