Fan Removal/Installation - Pacific energy Alderlea T5 Installation And Operating Instrictions

7) Install fan shield as shown in Fig. #13. Be sure to place the
air inlet opening against the surround side.
8) Install the cast decorative top by tilting it at a slight angle,
sliding it under the surround top, and settling it over the fan
shields. (Fig #14).
9) Be sure to engage fan shield tops in the slots on the underside
of the cast decorative top. (Fig. #15)
Fig. # 13
AIR INLET
SURROUND
SIDE
Fig. # 14
ALT5.CPINSB 180314-24
Fig. # 15
SLOT

Fan Removal/Installation

1) Remove Decorative Top and both Fan shields as specifi ed in
"Fan Speed Control Relocation" section on page 11.
2) Disconnect fan wires as shown in Fig #16 from appropriate
fan that is being replaced. Remove Thermal switch if needed.
(Fig #17)
3) Remove the two screws securing the fan bracket to the stove
using a 7/16" socket or wrench. Reverse steps 1&2 to install
new fan.(Fig #17)
Fig. # 16
Fig. # 17
SCREWS
THERMAL
SWITCH
11