Pacific energy Alderlea T5 Installation And Operating Instrictions page 13

7) Remove the control assembly from the ashlip bracket on the
right hand side. Flip it over and reattach on the left hand side
of the ashlip (Fig #25). Use the upper screw holes for best
alignment.
Fig. # 25
SPEED CONTROL
8) Route cable from speed control to fan and reattach wire support
tabs on the underside of the ash lip. Note wire positions.
(Fig.26 & Fig.27)
WIRE SUPPORT TABS
Fig. # 26
Fig. # 27
ALT5.CPINSB 180314-24
9) Reconnect the wires to the fans (Fig.28) and re-attach thermal
ASHLIP BRACKET
snap switch (Fig.29). Refi t ash lip, sides and top. Ensure that
the power cable is correctly routed through the surround and
it is not touching the fi rebox side (Fig #30). Wire placement
is important to prevent damage to wires.
Fig. # 28
Fig. # 29
Fig. # 30
THERMAL
SWITCH
13