Generating A Printout - Sartorius CB Operating Instructions Manual

Generating a Printout

Purpose
You can generate a printout of weights
as well as other measured values and
identification codes for documentation
purposes. You can format the printout
to meet individual requirements.
Features
You can print two customized header
lines of 14 characters each. (These text
lines are entered either at the Sartorius
factory or on-site with a special
program that uses the BPI interface
command sequence).
Also, you can choose to print an indi-
vidual weight or net, gross and tare
weights.
Line format: You can configure a data
ID code of up to 6 characters each for
the values to be printed; this data ID
code is printed at the beginning of a line.
You can generate printouts either auto-
matically or by pressing the [PRINT]
key; the printout can be dependent or
independent of the scale's stability
parameter.
You can have the following values out-
put automatically if menu code 7. 1. 4
(printout with data ID codes) is selected:
– Average piece weight (wRef)
– Reference sample quantity (nRef)
Factory Settings of the Parameters
Header lines:
The header lines do not contain any
information in the standard factory
setting.
Manual/automatic print mode:
In the manual mode, an individual value
is printed when you press the print key;
in the automatic mode, values are print-
ed depending on the stability parameter
selected for the scale:
Manual after stability (6. 1. 2).
Line format:
You can configure a data ID code of up
to 6 characters for each of the values
to be printed: printout of the net, tare
and gross values; reference sample
quantity, average piece weight with
data ID codes (7. 1. 4).
§ To set the parameters, please see
the chapter on "Settings"
29