Sartorius CB Operating Instructions Manual page 38

Software Handshake
The software handshake is controlled via XON and
XOFF. When a device is switched on, XON must
be transmitted to enable any connected device to
communicate.
Activating Data Output
You can define the data output parameter so that
output is activated either when a print command is
received or automatically and synchronous with the
scale display or at defined intervals (see application
program descriptions ["Counting"] and automatic
print setting).
Data Output by Print Command
The print command can be transmitted by pressing
[PRINT] or by a software command (Esc P).
Automatic Data Output
In the "automatic print" mode, data is output to
the interface port without a print command. You can
choose to have data output automatically at defined
print intervals with or without the stability parameter.
Whichever parameter you select, the data will be output
as the readouts appear on the scale display. The display
update frequency depends on the menu setting for
"Adapt filter" 1.1.x.
If you select the automatic print setting, data will
be transmitted immediately the moment you turn
on the scale.
38