Basic Operation; Turning Power On; Volume Selection; Channel Selection - Icom IC-440 Instruction Manual

3

BASIC OPERATION

■ Turning power ON

q Push and hold
w If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block, as identi-
cal. Therefore "01234" and "56789" are the same.
[PWR]
F
SET
PRIO
SCAN SET P
TAG
LOW
O G P
RS
CH
SQL
e When the "PASWD" indication does not clear after input-
ting 4 digits, the input code number may be incorrect. Turn
the power off and start over in this case.
14
for 2 sec. to turn the power ON.
MONI
T SQL
SCAN
TAG
PRIO
SET P
SCAN O G P
KEY
O G P
TAG RS
RS
0 1
LOW
NUMBER
5 6

■ Volume selection

➥ Push
• " " appears when volume level 0 is selected (while the internal
speaker is muted).

■ Channel selection

PRIO
LOW
SET P
➥ Push
2 3 4
or
7 8 9
• While pushing and holding
changes continuously until channel 1 is selected.
• When channel 1 is selected, beeps are emitted.
• 'CB-XX' appears when the CB channel is selected and 'RX-XX'
appears when the RX channel is selected.
• "
or to select the desired volume level.
to enter the channel selection mode, then push
CH
SQL
to select the desired channel.
or
" appears when channel selection mode is selected.
, the displayed channel
Appears