Optional Brick Kit Installation - Jøtul GF 300 DV II Allagash Installation And Operation Instructions Manual

Optional Antique Brick Kit
# 155648
CAUTION!
THE BRICK PANELS AND LOG PARTS ARE EXTREMELY FRAG-
ILE. HANDLE WITH CARE.
Read these instructions before beginning the installa-
tion.
1. Remove the Top Plate. Simply lift it up off of the stove
body. It is not fastened.
2. Remove the Glass Frame. Disengage the two com-
pression latches located at the top of the firebox and
lift the glass frame up and off of the stove. See fig. 48.
3. If installed, remove the Logset. These parts are not
fastened. Simply lift them out of the firebox. You do
not have to remove the embers.
4. Install the Lower Rear Panel. Position it up against
the back wall, resting on the burner skirt. Fig. 49.
5. Install a Side Panel. Tilt the panel, bottom edge first,
into position against the side wall. The panel will
stand on its own against the wall, fitting snugly be-
tween the rear panel and the front wall of the firebox.
Fig. 50.
6. Install the Upper Rear Panel. Simply rest it on the
other two panels. Fig. 51.
7. Install the other Side Panel.
8. Reinstall the Logset. Refer to the Owner's Manual if
necessary. BE CERTAIN THAT NO EMBER STONES ARE
BLOCKING THE PILOT ASSEMBLY OPENING. Refer to fig.
36.
9. Replace the Glass Frame. Slide the frame down the
slot in the front of the firebox. Be sure to push the
frame into the slot in the bottom to ensure it is fully
seated. The gasket at the top of the frame should be
flush with the top of the firebox.
Pull the compression latches out to engage with the
top lip of the glass frame.
10. Replace the Top Plate.
Upper Rear Panel
220745
Left Panel
220746
Lower Rear Panel
Figure 47. Brick Kit Contents
Right Panel
220747
220744
Figure 48.
Disengage the
compression latches
to remove the glass
frame.
Figure 49. Install Lower Rear Panel
Figure 50. Install Side Panel
Figure 51. Install Upper Rear Panel
137775_Rev_K 7.29.10
27