Jøtul GF 300 DV II Allagash Installation And Operation Instructions Manual page 17

Fuel Conversion Procedure
1. Turn off gas supply to stove.
2. Remove the stove Top Plate.
3. Disengage the two Glass Frame Latches at the top of
the firebox. See illustration on page 5. Carefully lift the
glass panel up and out of the stove.
4. If installed, remove the Embers and Log Set using care
not to damage the fragile log parts.
5. Lift out the Burner Skirt- (Part 40, fig. 52 p.28).
6. Reach under the stove and remove the Air Shutter wing-
nut from its stud. As you face the right side, it is the one
closest to you. See fig. 22.
7. Lift out the Burner Plate: NOTE- There are no screws
securing the Burner to the floor of the firebox. Pull the
Air Shutter forward and lift the burner together with
shutter up and out of the stove as a unit. See fig. 23.
8. Change the Main Burner Orifice. See fig. 24. Using a ½"
open ended wrench or deep-well socket remove the
burner orifice from its brass elbow housing and replace
with the appropriate orifice supplied in the kit.
9. Replace the Air Shutter with its gasket and push it all
the way back to allow replacement of the Burner Plate.
Reattach the wingnut to the shutter stem under the
stove, but do not tighten. You will set its final position
later.
10. Replace the Burner Plate. Engage the burner tube with
the Air Shutter assembly as in fig. 25. Be sure the burner
is securely engaged with the two support brackets at
the front of the firebox and push the plate back toward
the rear of the firebox. When correctly positioned, there
will be 1/2" (13 mm) clearance between the burner plate
and the front of the firebox. See fig. 25.
11 . CHANGE THE PILOT ORIFICE: From within the firebox,
remove the Pilot Head by pulling it straight up from the
pilot base. See fig. 26. Using the 4 mm hex key included
with the kit, unscrew the pilot orifice (counterclock-
wise). Replace with the appropriate orifice:
12. Tighten orifice into the base of the pilot assembly.
To prevent bypass leaks, be sure the orifice is secured
tightly and flush with the base. Replace pilot head by
pushing it down onto the pilot base.
13. Replace the Variable Regulator. Using a Torx T-20 screw-
driver, remove the three screws from the front of the
valve regulator. See fig. 27.
14. Remove the Regulator Tower, Gasket, white plastic
disk, and Spring. Remove the black rubber gasket from
the valve. See fig. 27.
Air Shutter
Burner Plate
Figure 23. Remove the Air Shutter and Burner as a unit.
Burner Orifice
Figure 24. Change the Burner Orifice.
Figure 25. Correct Burner Position.
137775_Rev_K 7.29.10
1/2"
clearance
17