Table of Contents
Advertisement
4.
Connect a 40-pin flat cable from the CPU card/motherboard to the optical disk
drive.
5.
Plug in a peripheral power connector from the power supply to the optical disk
drive.
6.
Repeat Steps 3 ~ 5 if there is more than one drive.
7.
Return the drive bay unit into the chassis and fix it with the four screws.
2.5.2
Installing a 3.5" floppy disk drive
1.
Remove the front cover of one 3.5" drive bay.
2.
Insert one 3.5" floppy disk drive into the proper location in the FDD bracket and
fix it with four screws.
3.
Attach the FDD bracket to the drive bay unit and fix it with two screws.
4.
Connect a 34-pin flat cable from the CPU card/motherboard to the floppy disk
drive.
5.
Plug in a floppy drive power connector from the power supply to the floppy disk
drive.
2.5.3
Installing an internal hard disk drive in the 3.5" drive bay
1.
Insert one 3.5" hard disk drive into the proper location in the FDD bracket and fix
it with four screws.
2.
Attach the FDD bracket to the drive bay unit and fix it with two screws.
3.
Connect a 40-pin flat cable from the CPU card/motherboard to an ATA (IDE)
hard disk drive or a SATA cable to a SATA hard disk drive.
4.
Plug in a peripheral power connector from the power supply to the hard disk
drive.
2.5.4
Installing a SAS/SATA HDD in the front-accessible HDD tray
ACP-4320 accepts both SAS and SATA HDDs. It is not necessary to remove top
cover when installing a SAS or SATA HDD in any of the front-accessible HDD trays.
1.
Left-shift the key latch of one HDD tray to unlock the tray. Hold the handle of the
tray and draw it out from the chassis.
2.
Refer to Figure 2.7 and slide one hard disk drive into the proper location in the
tray and fix it with 4 ~ 6 screws.
ACP-4320 User Manual
Figure 2.7 Installing a SAS or SATA HDD
12
Advertisement
Table of Contents
