The following procedures are provided to assist you in installing a motherboard (or
backplane), disk drives, and plug-in cards into the ACP-4320. Please also refer to the
Appendix A, Exploded Diagram, for the detail parts of the chassis.
2.1
Removing the Top Cover
To remove the top cover, please refer to Figure 2.1.
2.2
Installing the Backplane or Motherboard
The ACP-4320 supports either up to 15-slot backplane, or ATX/microATX mother-
board. To install backplane or motherboard, please proceed as follows:
1.
Dismantle the hold-down clamp by removing the two screws on both ends.
2.
Find the yellow label (shown as Table 2.1) on the inside of the chassis bottom. It
shows the copper stub locations for attaching the specific backplane or mother-
board. Get the copper stubs from the accessory box and follow the table to
screw the copper stubs on the proper locations
ACP-4320 User Manual
Figure 2.1 Removing the top cover
6