Mitsubishi Electric FR-A8NC Instruction Manual page 65

 Reply code definition
The reply to the instruction execution is set to RWr2, 10, 12, 14, 16, 18.
When executing the frequency setting (RYD, RYE) or instruction code execution (RYF), check the reply code (RWr2) in the
remote register after execution.
Data
H0000 Normal
H0001 Write mode error
Reply
code
Parameter selection
H0002
error
H0003 Setting range error
H00 Normal
Reply H01 Write mode error
code 1

Frequency command
H03 (torque command)
setting range error
H00 Normal
H01 Write mode error
Reply
code 2
Parameter selection
H02
error
H03 Setting range error
64
DETAILS OF INPUT AND OUTPUT SIGNALS
Item
No error (normal completion of instruction code
execution)
Parameter write was attempted during operation
other than a stop in the network operation mode.
Unregistered code number was set.
Set data is outside the permissible data range.
No error (normal completion of instruction code
execution)
Parameter write was attempted during operation
other than a stop in the network operation mode.
Frequency (torque command) outside the range is
set
No error (normal completion of instruction code
execution)
Parameter write was attempted during operation
other than a stop in the network operation mode.
Unregistered code number was set.
Set data is outside the permissible data range.
Alarm definition Remarks
• Reply code to RWr2 when
Pr.544 = 0
• Reply code to RWw10, 12, 14,
16, and 18 when Pr.544 = 18
Reply code to RWr2 when
Pr.544  0,