• To continuously change the running frequency from the programmable controller
When the frequency (speed) setting completion (example: X100D) switches on, make sure that the reply code in the remote
register is 0000H and change the set data (example: W101) continuously.
• Program example for writing data to EEPROM
Modify the program on
page 83
Frequency setting command Y100D Y100E
Frequency setting completion X100D X100E
<Timing chart when writing to RAM>
Y100D
W101
Inverter
running
frequency
For EEPROM, write is made only once when Y100E is switched on.
If the set data is changed with Y100E on, it is not reflected on the inverter.
84
PROGRAMMING EXAMPLES
as follows:
<Timing chart when writing to EEPROM>
Y100E
W101
Inverter
running
frequency
()
()
Reflect to the inverter when Y100E turns on