Program Example For Setting The Operation Mode - Mitsubishi Electric FR-A8NC Instruction Manual

8.2

Program example for setting the operation mode

The following explains a program to write various data to the inverter.
The following explains a program to change the operation mode of station 1 inverter to network operation.
• Operation mode write code: HFB (hexadecimal)
• Network operation set data: H0000 (hexadecimal) (Refer to
• The reply code at the time of instruction code execution is set to D2. (Refer to
X0 X0F X1
0
M0 X20
7
M300
11
M301 X100F
13
M302 X100F
22
28
78
PROGRAMMING EXAMPLES
SW80.0
page 66)
page
M0
Check the data link status of the station 1
PLS M300
SET M301
MOV H0FB W102
Write operation mode write code (HFB)
to RWw2 and set data (H0000) to RWw3.
MOV H0 W103
SET Y100F Turn on the instruction code execution
request (RY0F)
RST M301
SET M302
Read reply code (RWr2) to D2 when the instruction
MOV W2 D2
code execution completion (RX0F) turns on.
Turn off the instruction code execution
RST Y100F
request (RY0F)
RST M302
END
64)