Table of Contents
Advertisement
The Video Sequence screen (refer to Fig. 20) contains the following parameters for channel (camera)
on screen sequential display configuration:
☞
Note: Video Sequence is a feature used to define the sequence of on screen display for each
channel (camera). User can select the channels (cameras) to be displayed on screen and define the
time interval between each display.
<Enable Tour>
: click on this
<Interval>: enter the time interval between each channel (camera) display
☞
Note: minimum interval is 5 seconds
<View 1>: select the channel (camera) or channels (cameras) to be added to the display sequence
<View 4>: select 4 channel (4 camera) display to be added to the display sequence
Alarm Tour Type: configure the display sequence when alarm is triggered
☞
Note: Please refer to the Tour selection of Motion Detect, Video Blind, and Video Loss under
Alarm Configurations
<Interval>: >: enter the interval for the alarm triggered channel (camera) display sequence
☞
Note: This parameter is corresponding to the alarm triggered channel (camera) display sequence.
Please refer to the Tour selection of Motion Detect, Video Blind, and Video Loss under Alarm
Configurations
<Return after finished>
display (View 1/View 4) after the alarm triggered sequence (Tour) is complete
☞
Note: This function is not related to the enabled video sequential display
<OK>: exit with the changes
<Cancel>: go back without the changes
4.7 On Screen Video Display Sequence
to enable the video sequential display feature
: click on this
to enable the return function to go back to the regular
84
Advertisement
Table of Contents
