Dynamic Domain Name System (Ddns) Setting - Security Cams AD-800 User Manual

<Receiver>: enter the receiver
<Tile>: enter the email message
<OK>: exit with the changes
<Cancel>: go back without the changes
<IP Filter>: (refer to Fig. 17.4)
<Enable>: enable the IP filter
<Restricted Type>: select the type of list to edit: "Blacklist" or "Whitelist"
. . .
: enter the IP to be added onto the list
<Add> Tab: click on to add the above entered IPs to the list
<Delete> tab: click on to delete the selected IPs from the list
<OK>: exit with the changes
<Cancel>: go back without the changes
☞
Note: "Blacklist" – the list of restricted IPs
"WhiteList" – the list of allowed IPs.

4.4.1 Dynamic Domain Name System (DDNS) setting

<DDNS>: Dynamic Domain Name System (DDNS) setting for internet remote viewing (refer to Fig.
17.5)
☞
Note: For the following DDNS parameter settings, user needs to have one active account from
DYNDNS for valid parameter values. Please visit dyndns.org to obtain an account if the user does
not have one.
<DDNS Type>: DYNDNS service is recommended
<Enable>: enable the DDNS
<Domain Name>: enter the domain name (example - <your domain name>.dyndns.org)
<User Name>: enter the user name
<Password>: enter the password
<OK>: exit with the changes
<Cancel>: go back without the changes
<FTP>: (refer to Fig. 17.6)
<Enable>: enable the FTP
<Server IP>: enter the FTP server IP
<Port>: enter the FTP port number
<User Name>: enter the user name
<Password>: enter the password
<Anonymous>: select to be anonymous
<Max File Length>: enter the maximum file length in Min.
<DirName>: enter the Dir name
<OK>: exit with the changes
<Cancel>: go back without the changes
<AlarmServer>: (refer to Fig. 17.7)
<Protocol Type>: only the type of GENERAL is available from the selection
<Enable>: enable the alarm server
68