Motion Detection - Security Cams AD-800 User Manual

The Motion Detection screen (refer to Fig. 9) contains the following parameters for motion detection
configuration:
<Channel>: select the corresponding channel (camera) for the motion detection setup
<Enable> : click on this
<Sensitivity>: select the motion detection sensitivity
<Region Set> tab: click on to switch to full screen for motion detection region setting
☞
Note: Click on a square to active the motion detection region. Click on the square again to de-
active the motion detection region. Right click then select <Back> to go back to the Motion Detect
menu
<Period Set> tab: click on the "Set "tab to configure the time interval of each day to activate the
motion detection (refer to Fig. 9.1)
☞
Note: Right click then select <Back> to go back to the Motion Detect menu
<Interval>: time interval between two adjacent detected motions
<Record Channel>: select the corresponding channel to start recording when the motion detection is
triggered
<Tour>: select the channel (camera) for sequential display when the corresponding motion detection
is triggered
<PTZ Activation Set> tab: click on "Set" tab to configure the PTZ cameras (refer to Fig. 9.2)
CAM 1:
None
Preset
Tour
Pattern
{0}
<OK>: exit with the changes
<Cancel>: go back without changes
<Delay>:
<Show Message>:
<Send Email>: select to enable the email alert when the motion detection is triggered
<Buzzer>: select to enable buzzer alert when the motion detection is triggered
<FTP upload>: select to enable FTP file upload when the motion detection is triggered
<OK> tab: exit with the changes
<Cancel> tab: go back without the changes
3.1 Motion Detect
to enable the motion detection
44