The Video Loss configuration screen (refer to Fig. 11) contains the following parameters for video
loss configuration:
<Channel>: select the corresponding channel (camera) for the video loss alert setup
<Enable>
: click on this
<Sensitivity>: select the video loss alert sensitivity
<Period Set> tab: click on the "Set " tab to configure the time interval of each day to activate the
video loss alert (refer to Fig. 9.1)
☞
Note: Right click then select <back> to go back to the video Loss menu
<Record Channel>: select the corresponding channel to start recording when the video loss alert is
triggered
<Tour>: select the channel (camera) for sequential display when the corresponding video loss is
triggered
<PTZ Activation Set> tab: click on "Set" tab to configure the PTZ cameras (refer to Fig. 11.1)
CAM 1:
None
Preset
Tour
Pattern
<OK>: exit with the changes
<Cancel>: go back without changes
<Delay>:
<Show Message>:
<Send Email>: select to enable the email alert when the video loss alert is triggered
<Buzzer>: select to enable buzzer alert when the video loss alert is triggered
<FTP upload>: select to enable FTP file upload when the video loss alert is triggered
<OK> tab: exit with the changes
<Cancel> tab: go back without the changes
Select on [Advanced] tab for
<Back>: back to previous screen
<Main Screen>: short cut to Main Screen
<Copy>: copy the content of schedule parameters
<Paste>: paste the copied schedule parameters
<Default>: reset to the default parameters
<Schedule>: short cut to Schedule
3.3 Video Loss
to enable the video loss alert
51