Encode - Security Cams AD-800 User Manual

The Encode configuration screen (refer to Fig. 15) contains the parameters for
configuration. The parameters on the left column are the relative setup for the remote monitoring
over the internet/network. The parameters on the right column are the relative setup for the remote
mobile device monitoring.
Parameters Default Setting Table
Channel
Compression
Resolution
Frame Rate (FPS)
Bite rate Type
Quality
Bit Rate(Kb/S)
I Frame Interval
Video/Audio
<Channel>: select the corresponding channel (camera) for the Encode setup
☞
<Compression>: Note: H.264 is recommended
<Resolution>: select the video recording resolution from the following options
CIF (352x240), DI (704x480), HDI (704x240), QCIF (176x120)
<Frame Rate (FPS)>: select the Frame Rate (Frames Per Second) from the list
<Bite rate Type>: select the bite rate type from CBR or VBR
☞
Note: CBR short for Constant Bite Rate. VBR short for variable Bite Rate
<Quality>: Select the video recording quality from the list
<Bit Rate(Kb/S)>: Bit Rate is fixed by the resolution setting
☞
Note: Kb/S stands for Kilobit per second
<I Frame Interval>:
<Video/Audio>: select to enable the video and audio to corresponding data streaming
<OK> tab: exit with the changes
<Cancel> tab: go back without the changes
Select on [Advanced] tab for
<Back>: back to previous screen
<Main Screen>: short cut to Main Screen
<Copy>: copy the content of schedule parameters

4.2 Encode

Main Video Streaming
1
H.264
CIF(352x240)
25
VBR
Good
437
2
[ V ] [ ]
Video Enable Audio Enable
video streaming
Remote Mobile Device Video
Streaming
Extra Stream
QCIF(176x120)
25
VBR
General
164
2
[ ] [ ]
Video Enable Audio Enable
63