Alarm Input - Security Cams AD-800 User Manual

The Alarm Input configuration screen contains the following parameters:
<Alarm In>: select the corresponding alarm channel for the alarm input setup
<Enable>: select to enable the alarm input
<Period Set> tab: click on the "Set " tab to configure the time interval of each day to activate the
alarm input alert
Note: Right click then select <back> to go back to the alarm input menu
<Interval>: the interval time between the two adjacent alarms
<Alarm Output>: select the alarm output when the alarm input alert is triggered (there is only one
alarm output channel for 4/8 channel DVR)
<Delay>: enter the delay in seconds to generate the alarm output when
alert is triggered
<Record Channel>: select the corresponding channel to start recording when the alarm input alert is
triggered
<Tour>:
<PTZ Activation Set> tab: click on "Set" tab to configure the PTZ cameras
CAM 1:
None
Preset
Tour
Pattern
{0}
<OK>: exit with the changes
<Cancel>: go back without changes
<Delay>:
<Show Message>:
<Send Email>: select to enable the email alert when the alarm input alert is triggered
<Buzzer>: select to enable buzzer alert when the alarm input alert is triggered
<FTP upload>: select to enable FTP file upload when the alarm input alert is triggered
<OK>: exit with the changes
<Cancel>: go back without the changes
Select on [Advanced] tab for
<Back>: back to previous screen
<Main Screen>: short cut to Main Screen
<Copy>: copy the content of schedule parameters
<Paste>: paste the copied schedule parameters
<Default>: reset to the default parameters
<HDD Mgmt>: short cut to HDD Mgmt

3.4 Alarm Input

the alarm input
54