Video Blind - Security Cams AD-800 User Manual

The Video Blind screen (refer to Fig. 10) contains the following parameters for video blockage
configuration:
<Channel>: select the corresponding channel (camera) for the video blockage alert setup
<Enable>: select to enable the video blockage alert
<Sensitivity>: select the video blockage alert sensitivity
<Period Set> tab: click on the "Set" tab to configure the time interval of each day to activate the
video blockage alert (refer to Fig. 9.1)
☞
Note: Right click then select <Back> to go back to the Video Blind menu
<Record Channel>: select the corresponding channel to start recording when the video blockage
alert is triggered
<Tour>: select the channel (camera) for sequential display when the corresponding video blockage
is triggered
<PTZ Activation Set> tab: click on "Set" tab to configure the PTZ (refer to Fig. 10.1)
CAM 1:
None
Preset
Tour
Pattern
{0}
<OK>: exit with the changes
<Cancel>: go back without changes
<Delay>:
<Show Message>:
<Send Email>: select to enable the email alert when the video blockage alert is triggered
<Buzzer>: select to enable buzzer alert when the video blockage alert is triggered
<FTP upload>: select to enable FTP file upload when the video blockage alert is triggered
<OK> tab: exit with the changes
<Cancel> tab: go back without the changes
Select on [Advanced] tab for
<Back>: back to previous screen
<Main Screen>: short cut to Main Screen
<Copy>: copy the content of schedule parameters
<Paste>: paste the copied schedule parameters
<Default>: reset to the default parameters
<Schedule>: short cut to Schedule

3.2 Video Blind

48