Ide Master, Ide Slave; Bios Menu 5: Ide Master And Ide Slave Configuration; Configure Sata As [Ide]; Auto-Detected Drive Parameters - IEI Technology AFL-W19A User Manual

PATA Only

Configure SATA as [IDE]

Use the Configure SATA as option to configure SATA devices as normal IDE devices.
IDE D
EFAULT
RAID
AHCI

3.3.2.1 IDE Master, IDE Slave

Use the IDE Master and IDE Slave configuration menu to view both primary and
secondary IDE device details and configure the IDE devices connected to the system.
Main Advanced PCIPNP
Primary IDE Master
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
Device :Not Detected
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
Type
LBA/Large Mode
Block (Multi-Sector Transfer)
PIO Mode
DMA Mode
S.M.A.R.T.
32Bit Data Transfer
v02.61 ©Copyright 1985-2006, American Megatrends, Inc.

BIOS Menu 5: IDE Master and IDE Slave Configuration

Auto-Detected Drive Parameters

The "grayed-out" items in the left frame are IDE disk drive parameters automatically
detected from the firmware of the selected IDE disk drive. The drive parameters are listed
as follows:
Device: Lists the device type (e.g. hard disk, CD-ROM etc.)
Page 50
AFL-W19A/17D/W15A-N270 Panel PC
Only the IDE drives are enabled. SATA drives are
disabled
Configures SATA devices as normal IDE device.
Used when a RAID setup is installed
Enables advanced SATA drive features
BIOS SETUP UTILITY
Boot Security
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
Chipset Power
Select the type
of device connected
to the system
Select Screen
↑ ↓
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Exit