Ide Master, Ide Slave; Bios Menu 5: Ide Master And Ide Slave Configuration; Auto-Detected Drive Parameters - IEI Technology ACT-412A-N270 User Manual

ACT-412A-N270 User Manual
SATA Pri,
PATA Sec
PATA Only

5.3.2.1 IDE Master, IDE Slave

Use the IDE Master and IDE Slave configuration menu to view both primary and
secondary IDE device details and configure the IDE devices connected to the system.
Main Advanced PCIPNP
Primary IDE Master
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
Device :Not Detected
⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯⎯
Type
LBA/Large Mode
Block (Multi-Sector Transfer)
PIO Mode
DMA Mode
S.M.A.R.T.
32Bit Data Transfer
v02.61 ©Copyright 1985-2006, American Megatrends, Inc.

BIOS Menu 5: IDE Master and IDE Slave Configuration

Auto-Detected Drive Parameters

The "grayed-out" items in the left frame are IDE disk drive parameters automatically
detected from the firmware of the selected IDE disk drive. The drive parameters are listed
as follows:
Device: Lists the device type (e.g. hard disk, CD-ROM etc.)
Type: Indicates the type of devices a user can manually select
Vendor: Lists the device manufacturer
Size: List the storage capacity of the device.
LBA Mode: Indicates whether the LBA (Logical Block Addressing) is a method
of addressing data on a disk drive is supported or not.
SATA drives are configured on the Primary IDE
D
EFAULT
channel. IDE drives on the Secondary IDE channel
Only the IDE drives are enabled. SATA drives are
disabled
BIOS SETUP UTILITY
Boot Security
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
Chipset Exit
Select the type
of device connected
to the system
Select Screen
↑ ↓
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
Page 79