Installing Fabric Clothing Guards - Invacare XtraTM 1026793 Operator And Maintenance Manual

SECTION 6—SEAT
Rear Edge of
Seat Rail
NOTE: Only Hook and Loop style seat positioning strap shown. Auto style seat positioning strap
attaches the same way.
FIGURE 6.3 Installing/Removing Seat Positioning Strap

Installing Fabric Clothing Guards

NOTE: For this procedure, refer to FIGURE 6.4.
1. Remove the seat cushion, if necessary.
2. Secure the fastening straps of the fabric
clothing guards to the fastening straps
on the seat upholstery.
3. Reinstall the seat cushion, if necessary.
4. Remove the two (2) phillips screws that
secure the back upholstery to the back
canes.
5. Position the D-rings on the mounting
holes in the back canes.
6. Reinstall the two (2) phillips screws.
Torque to 20-25 in./lbs.
7. Run the nylon cord evenly through the
two (2) D-rings.
8. Run the nylon cord through the cord
lock.
9. Push star wheel into cord lock to hold
the nylon cord in place.
10. Tie a knot in the nylon cord and cut the
excess, if desired.
Xtra™
Rearmost
Mounting Screws
Seat
Seat Positioning
Strap Half
Seat Positioning
Strap Half
Card Lock
Phillips Screw
D-ring
FIGURE 6.4 Installing Fabric Clothing
40
Fabric Clothing
Guard
Fastening
Strap
Seat Upholstery
Phillips
Screw
D-ring
Star Wheel
Nylon Card
Guards
Part No 1026793