Installing Clothing Guards - Invacare XtraTM 1026793 Operator And Maintenance Manual

Installing Clothing Guards

NOTE: For this procedure, refer to FIGURE 6.5.
1. Position the threaded and unthreaded half clamps on inside and outside of the
wheelchair frame.
NOTE: Make sure the threaded half clamp is on
the outside of the wheelchair frame.
2. Loosely install the washer and socket
screw into the unthreaded and
threaded half clamps.
3. Determine the desired rigid clothing
guard position and securely tighten the
two (2) half clamps together with the
socket screw.
4. Insert the rigid clothing guard into the
slot on the threaded half clamp.
5. Repeat STEPS 1-4 for the opposite rigid
side guard.
Part No 1026793
Wheelchair
Frame
Rigid Clothing
Guard
Slot
Threaded Half Clamp
FIGURE 6.5 Installing Clothing Guards
41
SECTION 6—SEAT
Half Clamp
Socket Screw
Washer
Xtra™