Replacing Armrests; Replacing Desk/Full Length Armrest Pad (Fixed Height Arms Only); Replacing Clothing Guards (Fixed Height Arms Only); Converting Between Space Saver And Conventional Arms - Invacare 9000 SL Owner's Operator And Maintenance Manual

SECTION 5—ARMS

Replacing Armrests

NOTE: Armrest release levers MUST be in the unlocked position when placing armrest into the
arm sockets.
1. Place armrest into arm sockets located on the side of the wheelchair.
2. Lock the armrest by turning the armrest release levers towards the inside of the
wheelchair.
Replacing Desk/Full Length Armrest Pad (Fixed Height
Arms Only)
NOTE: For this procedure, refer to FIGURE 5.4.
1. Remove the mounting screws that
secure the armrest pad to the armrest
assembly.
2. Replace armrest pad and securely
tighten with the existing mounting
screws.
Replacing Clothing Guards
(Fixed Height Arms Only)
NOTE: For this procedure, refer to
FIGURE 5.4.
1. Remove the four mounting screws that secure the existing clothing guard to the
armrest assembly.
2. Install new clothing guard and securely tighten with the existing mounting screws.
Converting Between Space Saver and Conventional
Arms
NOTE: For this procedure, refer to FIGURE 5.5.
NOTE: Space Saver arms do not work with the following:
• 9000XT/9000SL with the adjustable angle back option.
• 9000XT Recliner.
1. Remove the arms from the wheelchair. Refer to Removing or Replacing Armrest on
page 41.
2. Remove the locknut and hex screw that secure the arm socket to the wheelchair frame.
3. Repeat STEP 2 for the opposite side of the wheelchair.
9000 Series
Mounting Screws
Clothing
Guard
Mounting Screws
FIGURE 5.4 Replacing Desk/Full Length
Armrest Pad (Fixed Height Arms Only)
42
Armrest Pad
Armrest
Assembly
Mounting Screws
Part No.1056953