Heel Loop Replacement; Installing Impact Guards/Calf Strap - Invacare XtraTM 1026793 Operator And Maintenance Manual

Heel Loop Replacement

NOTE: For this procedure, refer to FIGURE 4.8.
1. Remove the hex screw and coved washer that secures the lower half of the footrest to
the swingaway footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the phillips screw and locknut
that secure the heel loop to the footrest.
4. Slide heel loop over slide tube of
footrest assembly.
5. Replace heel loop.
6. Reverse STEPS 1-5 to reassemble.
NOTE: When securing the heel loop to the
footrest assembly, tighten the phillips screw
and locknut until the spacer is secure.

Installing Impact Guards/Calf Strap

NOTE: For this procedure, refer to FIGURE 4.9.
1. Remove impact guard/calf strap from
packaged container if not already
secured to the footrest.
2. Secure the impact guards to the footrest
frame.
3. Secure the optional calf strap around
the footrest frame (with the impact
guards attached).
Part No 1026793
SECTION 4—FRONT RIGGINGS
Composite/Aluminum/Tubular Footplates
Hex Screw/Coved Washer
FIGURE 4.8 Heel Loop Replacement
Swingaway Front Frame
Calf Strap
Impact
Guard
FIGURE 4.9 Installing Impact Guards/Calf
33
Phillips Screw
Spacer
Locknut
Strap
Xtra™