Adjusting Calfpads; Installing Adjustable Angle Flip-Up Footplate Hinge - Invacare XtraTM 1026793 Operator And Maintenance Manual

Adjusting Calfpads

NOTE: For this procedure, refer to
FIGURE 4.5.
1. To adjust the calfpad, turn pad towards
the outside of the wheelchair.
2. Slide the calfpad up or down until the
desired position is obtained.
3. To secure the calfpad, turn the calfpad
towards the inside of the wheelchair.

Installing Adjustable Angle Flip-Up Footplate Hinge

NOTE: For this procedure, refer to FIGURE 4.6.
NOTE: This procedure is for individual adjustable angle footrests only.
1. Position the adjustable angle flip-up footplate hinge on the footrest support tube at the
desired height.
2. Position the hardware on the footrest support (FIGURE 4.6).
3. Flip the footplate hinge to the UP position.
NOTE: The footplate hinge will fall to the
DOWN position.
4. Tighten the socket screw and locknut
that secure the footplate hinge to the
footrest support until the footplate
hinge remains in the UP position.
5. Check the up and down motion of the
footplate hinge to make sure the user of
the wheelchair can operate the
footplates easily.
NOTE: If the footplate's motion is too tight,
loosen the socket screw and locknut
approximately
1/4-turn.
NOTE: If the footplate's motion is too loose,
tighten socket screw and locknut
approximately
1/4-turn.
Part No 1026793
SECTION 4—FRONT RIGGINGS
Adjust Calfpad
FIGURE 4.5 Adjusting Calfpads
Locknut
Footplate
Hinge
FIGURE 4.6 Installing Adjustable Angle Flip-
Up Footplate Hinge
31
Calfpad
Secure Calfpad
Footrest
Support
Tube
Socket Screw
Xtra™